Before you start
Tools: 800 and 1200 paper, grey scotch, hand block, prep sol, booth prep zone light.
When: any panel prepped for base or blend.
Steps
- 01PrepperAsk the painter where the base stops and the blend starts. Mark it on the panel with tape or pencil.
- 02PrepperSand the base area with 800.
- 03PrepperSand the blend area with 1200, then grey scotch. No 800 in the blend area.
- 04PrepperDo all edges, swage lines, bars and small plastics by hand. Light pressure. Never the machine on an edge.
- 05PrepperCheck every edge under the prep zone light before the panel leaves you.
- 06PrepperRub-through found? Fix it now. If you can't, flag it on the panel (tape tag: "RT" plus an arrow) and tell the painter.
- 07PrepperPut your initials on a tape tag on each panel. You prepped it, you own it.
- 08PainterWipe on prep sol in the booth and check every edge while it is wet. Rub-throughs show best wet.
- 09PainterRub-through found in the booth? Stop. Fix it before base. Tell the workshop manager: job number, panel, prepper initials.
Done when
- Every panel passed the light check (prepper) and the wet check (painter).
- No rub-through found after clear.
Watch out
- Blend back edges: the last rub-through was here, on a blend panel with only a chip on the front guard.
- Bars and small plastics rub through fastest. Hand only, extra light.
!Two people checked the last one dry and still missed it. The wet check (step 8) is not optional.
- V106/11/2026First version, from the paint team meeting.